2 dr sedan 1/4 window question

They're just the rubber pieces, right Johnny? You use some 3M weatherstrip adhesive to glue them in.

Randy (not too much though!)

they're the channels the window rides in... the factory channels have "nubs" that fit into a hole... the new/replacement don't have the "nubs"


"RICH" fron "over there" told me a while back... but i ferget

John, that is why you are supposed to WRITE IT DOWN!!!!

Randy (I know, ya ferget that too!!)

i can read, but i dunno how ta write

John,
3M Super Weatherstrip Adhesive Holds Very Well.
Joe

You could also use Window Urethane,but it would be a Problem if you had to get into it later.
Joe

10-4 thanks for the confirmation Joe... thanks ta "Walt" also


(that's Randy ta those who dunno)

i'll use the 3M

thanks again Joe

Make sure you dont get any on your fingers, otherwist we'll have to read this all day. sksksksksksksksksksksksksksksksksksksksksksksksksk

Hey Guys, what have ya done on yer side glass ??? i'm thinking of running to a glass shop and having them hook me up with new stuff... it's flat so i figgered it'd be somewhat inexpensive (inexpensive, what's that ???)

where do ya get yours and do ya have an idea on cost ???



Thanks
#269

SHIFTY4 said:

Hey Guys, what have ya done on yer side glass ??? i'm thinking of running to a glass shop and having them hook me up with new stuff... it's flat so i figgered it'd be somewhat inexpensive (inexpensive, what's that ???)

where do ya get yours and do ya have an idea on cost ???



Thanks
#269

Click to expand...

I took my old glasses from my '66 Sedan to a local glass shop and had new ones (with a light charcoal tint) cut. Both quarter glasses, door glasses and vent glasses was between $200 and $300. I can't remember exactly how much.

Lynn

Thanks Lynn, that sounds reasonable ta me... hopefully my shops are in line with yours... i was thinking about getting my wiring harness, maybe i'll scoot to the glass shop instead..


hey Lynn... did you install all yer window channel stuff yerself ??? any tips you could share ???

appreciate it, fer glass and channel info

Yeah, I installed mine. I used 3M black adhesive. I think the part # is 08011. I shaped the new channel and then put the glue on and rolled the window up tight to hold it in place while it set up. I finished the car this past December and so far no problems. It wasn't too much of a job. If I can be of further help, just let me know.

Lynn

Thanks Lynn... sounds easy enough i guess i'd get ragged if i didn't try... i think i'll have ta give 'r a whirl

appreciate the help and i take confidence in yer words... Thanks