Chevrolet Nova Forum banner

Starting my 64 Chevelle (video)

3K views 5 replies 2 participants last post by  Little Red Wagon! 
#1 ·
Well i've been working on this 64 chevelle off and on for about 2 years ( it's hard to put a car back together that was stollen and stripped from you!!!). i finally got to hear it make some noise!!!! it's not ready to drive yet but with a battery on the floor, a small fuel pump, and a gas can, she runs!!!!

It's a .030 over 400 with an ohio steel crank, eagle H-beam 5.7 rods, 14:1 pistons, motown 220 heads, the cam is a solid roller herbert 261-270 @ .050 .625 lift 106 lobe center, super victor dominator manifold, 1050 hp series dominator on top.

I wish the sounds was a little better. now i wonder what it would run in the 1/4?????

let me know what you think??? thanks for all the help.......steve

[ame="http://www.youtube.com/watch?v=BGGp7dl_8Ew"]YouTube - Starting up my '64 Chevelle[/ame]
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top