Lots of parts from a straight car. even some trim pieces. Car was a 6 cyl. powerglide car. No rear end that's mine. but the 4 lug off my 63 will be available as well as the 4 lug front assemblies. I also have some straight strut rods since I put the cpp in. PM if you have any questions on stuff.

Jeff

Do you have the trim pieces that are at the base of the sail panels, on the top of the quarters on the outside?

Slowly getting this thing torn apart.

The seats are in great shape. Black cloth with no rips.

Two sets of back windshield chrome trim.

Steel hood with 65 Die cast mounted on it I'll separate these two if the hood is interchangeable with other 1st gens (62-64)?

Blue steering wheel with complete horn ring actually the whole steering column can go if you want an automatic setup.

Factory A/C unit under dash.

Chrome drip rails around all the doors.

Back windshield no cracks.

more to come stay tuned.

Jeff

hows the body chrome?

hows the body chrome?

Body chrome is non existant with the exception of the pieces that go on the door next to the windows. I have two grills 65 that are pretty beat and I have a 64 grill complete with brackets the grill is beat but the pieces are still ok.

I've got a couple of easy ones for ya. I need the thermostat housing that bolts to the block (not the water neck) the one where the idiot light sending unit screws into. Also the ignition clynder nut. Do you have these and if so how much.

Thanks

Tom

I've got a couple of easy ones for ya. I need the thermostat housing that bolts to the block (not the water neck) the one where the idiot light sending unit screws into. Also the ignition clynder nut. Do you have these and if so how much.

Thanks

Tom


Tom,

Sorry but this car didn't have an engine and my 6 from my 63 went to a guy in Tennessee. I do think I have the cyinder nut for the ignition though. Is that the chrome nut that hold the key cylinder in the dash?

Jeff

Jeff thanks for the reply. I actually just found my ignition nut (It was lost) so i will no longer be needing that. but thanks again

Tom

are the seats interchangeable with two doors? i could use some seats and seatbelts. thanks much! how much?

the seats are different between 4 doors and 2 doors.

Jeff

do you still have the factory under the dash a/c system

Two sets of back windshield chrome trim.

Steel hood with 65 Die cast mounted on it I'll separate these two if the hood is interchangeable with other 1st gens (62-64)?

Blue steering wheel with complete horn ring actually the whole steering column can go if you want an automatic setup.

Factory A/C unit under dash.

Chrome drip rails around all the doors.

Back windshield no cracks.

more to come stay tuned.

Jeff[/quote]

do you still have the factory under dash a/c unit.

car is gone. A/C unit was in bad shape and went with car. The more I tore into it the worse it got. Sorry.

Jeff