Well I Got The Wiper Motor And Installed It.i Blew A Fuse When I Was Hooking The Wires Back Up.must Of Not Payed Any Attention To The Wiring When I Removed The Wires.i Replaced The Fuse And Now I Dont Have Any Power To The Plugs.suggestions
Go Back To Wiper Switch Go To Key Switch.

Pull out new fuse and check with a multi-meter, also before you pull it you can check to see if you have voltage on one side but not the other side of the fuse when the switch is on. Some fuses look OK, but are not. You could have also blown the fuse right away. If this is the case check wiring for a ground.